Wednesday, April 8, 2015

Innokin iTaste VV4-M Express Kit 1000mAh

Based on the bestselling Innokin iTaste VV v3.0 comes the iTaste VV4 featuring a wider range of Variable Voltage and Variable Wattage, advanced safety features, and the famous “Vape While You Charge” technology. Variable voltage on the iTaste VV v4.0 is adjustable in 0.1 increments from 3.0V to 6.0V. The watts on this awesome battery are adjustable from 6.0 to 15.0 in 0.5 increments.

The high quality OLED screen looks great and clearly displays the resistance of the attached tank & coil, voltage, wattage and also accurately shows the remaining battery charge. The iTaste VV4 is an affordable, reliable, and ultimately satisfying daily vape device.

Specifications:

Dimension: 5-1/8"L x 5/8"W
510 and eGo Threaded
Operating Voltage: 3.0V-6.0V
Charging Time: 1.5 Hours
Operating Voltage: 3.3V-5.0V
Operating Wattage: 6.0W-15.0W
Minimum Resistance: 0.8 ohms

The Primary Features of The iTaste VV4

Passthrough:
The iTaste VV4 is charged through a Micro USB Port. You can recharge it with any standard MicroUSB cable. It can also work as a pass-through device for simultaneous vaping and charging. The battery must contain a small charge before it can be used in this way. If you're using the battery quicker than it can charge, the battery will shutoff. We suggest charging the battery for 10-15 minutes before using it.

Battery Level Indicator:
The iTaste VV4 battery capacity is displayed via green, yellow and red LED lights.
Green = Almost fully Charged. When the iTaste VV4 is fully recharged the LED light will power off.
Yellow = Half Power.
Red = Low Power. Charge the VV4.

Variable Voltage:
Voltage can be adjusted from 3.0 – 6.0 volts in .1 volt increments.

Variable Wattage:
Wattage can be adjusted from 6.0 – 15.0 Watts in .5 watts increments.

Large battery capacity:
The iTaste VV4 has a built-in mAh polymer Li-Ion rechargeable battery.

ON/OFF battery switch:
Press the power button three times in rapid succession to turn on the iTaste VV4. Once the iTaste VV4 is On hold down the power button to activate the atomizer and vape. When the iTaste VV4 is not in use, press the power button three times in succession to power off the iTaste VV4 Advanced Personal Vaporizer. Always power off the iTaste VV4 Advanced Personal Vaporizer when it is not being used, or when it is going to be stored in a pocket, bag or purse.

10 second cutoff:
If the activation button is held for 10 seconds or longer the iTaste VV4 Advanced Personal Vaporizer will stop firing until the button is released and pressed again.

Low Voltage Warning:
The Red LED and Battery bar will continue blinking when the battery capacity is lower than 3.3V and the iTaste VV4 Advanced Personal Vaporizer will power off automatically.

Short Circuit/Atomizer Protection:
Short Circuit/Atomizer Protection protects the iTaste VV4 Advanced Personal Vaporizer against shorted atomizers and will stop the unit from functioning in unsafe conditions.

The iTaste VV4 features automatic real-time atomizer Ohms detection. If the resistance of the atomizer is lower than 0.8 the Ohms bar will blink.
If there is a short circuit the VV4 screen will display the following and the LED light will power off.

Over-Discharge Protection:
The iTaste VV4 Advanced Personal Vaporizer monitors the battery voltage and will automatically power off when the battery is discharged.

How about Eleaf iStick 10W 1050mAh VV VW Battery ,How do you know iStick 10W? maybe you could to know iStick 10w first and then you can write a post about Eleaf iStick 10W 1050mAh VV VW Battery VS. Innokin iTaste VV4-M Express Kit 1000mAh



0 comments:

Post a Comment